Washer use, Starting your washer, Fire hazard – Kenmore HE3 4785 User Manual

Page 12: Using the proper deteit|ent, First wash cycle without laundry, For all wash cycles, Notes, Using the proper detergent, O; o, Warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

WASHER USE

^er My^cie Normal / Casual.

Heavy Duty, />

Prewash

Soak

o

o

Whitest Whites.

Express Wash

Rinse / Drain
& Spin

• Clean Washer

O

ptions

2nd Rinse

Extended

Spin

Button

Sounds

Delay

Start

O
O

o

o

DO

J I

C

ycle

S

tatus

Add Píe- Wash Rinse Spin Clothes

Clothes Wæh

Oean

|Hot

1 High

H warm*

H Medium

1 Heavy coJîBof

B Warm

H Low

iLoud

1 Normal

■ Coo!

H Extra Low

■ Soñ

^ Light

pCold

^No Spin

|Off

o

O

o

; o

Soil Level

Wash Temp

Spin Speed

1 Cycle Signal

!»• HOüufoiocK/

l.íNLOCX CONI ROIS

Starting Your Washer

^WARNING

M

Fire Hazard

Never place items in the washer that are dampened

with gasoline or other flammable fluids.

No washer can completely remove oil.

Do not dry anything that has ever had any type of oil on
it (including cooking oils).

Doing so can result in death, explosion, or fire.

WARNING:

To reduce the risk of fire, electric shock, or injury to

persons, read the IMPORTANT SAFETY INSTRUCTIONS before

operating this appliance.

The following is a guide to using your washer. Please refer to
specific sections of this manual for more detailed information.

Do not store laundry products on the top surface of this washer.

Vibration is normal during operation.

Using the Proper Deteit|ent

Use only High Efficiency detergents. The package for this type of

detergent will be marked “HE” or “High Efficiency.” This wash

system, along with less water, will create too much sudsing with a
regular non-HE detergent. Using regular detergent will likely result
in washer errors, longer cycle times and, reduced rinsing
performance. It may also result in component failures and
noticeable mold or mildew. HE detergents are made to produce

the right amount of suds for the best performance. Follow the

manufacturer's instructions to determine the amount of detergent

to use.

Use

only “HE” High Efficiency detergent

First Wash Cycle Without Laundry

Before washing clothes for the first time, if not completed during

the final installation step, choose the Normal/Casual cycle and

run it without clothes. Use only HE High Efficiency detergent. Use
V

2

the manufacturer’s recommended amount for a medium-size

load. This initial cycle serves to ensure the interior is clean before

washing clothes.

For All Wash Cycles

1. Open the washer door by pulling on the handle. Sort laundry

according to color and type of fabric. Place a load of sorted
clothes in the washer. Do not overload washer. Overloading
can cause poor cleaning.

■ The washer can be fully loaded, but not tightly packed.

Washer door should close easily.

■ Mix large and small items. Avoid washing a single item.

Load evenly.

■ Wash small items such as infant socks in mesh garment

bags. It is recommended that more than one garment bag
be used and that each garment bag be filled with equal
amounts of material.

■ When unloading garments, check under the gray colored

seal at the front of the tub for small items.

Olose the washer door by pushing it firmly until the lock
clicks. The washer door will remain locked during the wash
cycle.

NOTES:

■ After any wash cycle is completed, the door must be

opened and then closed before a new cycle can begin.

■ The door can be opened only if STOP is selected while

the ADD CLOTHES light is glowing or if the cycle has

been canceled.

See “To cancel a cycle”
Modifiers” section.

in “Changing Cycles, Options and

3.

4.

Open the dispenser drawer and add laundry products to the
detergent, bleach, or fabric softener compartments. Close
drawer slowly to avoid spills. See “Using the Dispenser.”

Turn on the washer by selecting POWER. Select one of the

cycles by turning the cycle selector. The indicator light for the
selected cycle will glow green. When you are selecting a

wash cycle, the preset modifiers (Soil Level, Wash Temp and

Spin Speed) for the cycle, will glow green. Selectable options

will glow amber. If an option or modifier is unavailable with
the selected cycle, the light will not illuminate. The preset

settings provide the recommended fabric care for the
selected cycle. The display shows the estimated time
remaining. See “Cycles.”

12

Advertising
This manual is related to the following products: