Did you add detergent to the dispenser, Load is wrinkled, Did you unload the washer promptly – Kenmore HE3 4785 User Manual

Page 24: Did you properly sort the load, Cycle too long, Is “sud” shown in the display, Did the load cause imbalance, Door locked at end of wash cycle

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Stains on load

Gray whites, dingy colors

Did you add detergent to the dispenser?
For best results, add detergent to the detergent
compartment. Do not add detergent to the washer drum.

Did you use enough HE detergent?
Use enough detergent to remove soil and hold it in
suspension. Use only HE detergent. Follow the
manufacturer's instructions to determine the amount of
detergent to use.

Is there above average iron (rust) in water?

You may need to install an iron filter.

Did you properly sort the load?
Sort dark clothes from whites and lights.

Did you unload the washer promptly?

To avoid dye transfer, unload the washer as soon as it stops.

Did you use a fabric softener dispensing ball?
Dispensing balls will not operate correctly with this washer.

Add liquid fabric softener to the fabric softener compartment.

Did you use powdered detergent in a low-speed cycle?
Consider using liquid detergent.

Did you use Express Wash on a large load?
For best results, use Express Wash for small, lightly soiled
loads.

Load is wrinkled

Did you unload the washer promptly?
Unload the washer as soon as it stops.

Did you use the right cycle for the load being washed?
Use the Silk/Ultra Delicate cycle or another cycle with a low
spin speed to reduce wrinkling.

Did you overload the washer?

The wash load must be balanced and not overloaded. Loads

should tumble freely during washing.

Did you properly sort the load?
Dye transfer can occur when mixing whites and colors in a

load. Sort dark clothes from whites and lights.

Was the wash temperature too low?

Use hot or warm washes if safe for the fabric load. Make sure

your hot water system is adequate to provide a hot water
wash.

Did you use enough detergent, or do you have hard

water?

Use more detergent for washing heavy soils in cold or hard

water.

Cycle too long

■ Is “SUD” shown in the display?

Excessive sudsing has been detected and a suds routine has

been started to reduce excessive suds. This routine will add

time to the original cycle.

■ Did the load cause imbalance?

When too much imbalance occurs, an imbalance routine will

start to redistribute the load. During the imbalance routine the

time displayed may pause until this activity is complete, then

resume with the remainder of the cycle.

■ Did you wash a large load on the Express Cycle?

The Express Cycle is designed for smaller load sizes

(2-3 items) of lightly soiled garments. If larger loads are

washed in this cycle, wash time will be increased.

■ Did you wash a large load in a gentle or Delicate cycle?

When using Express Wash, Handwash/Delicate cycles, you

should use small loads. This ensures a gentle wash for your
garments without increasing cycle times.

Door locked at end of wash cycle

Did all of the water drain out of the washer during the

spin?
Select DRAIN & SPIN to remove any water remaining in the

washer. The washer door will unlock at the end of the drain.

24

Advertising
This manual is related to the following products: