Kenmore 596.50002100 - Manual (Page 15)

(RESH fOOD FEJiWS
nw ms
A CAUTION
To avoid personal injury or property
damage, observe the following;
> Confirm shelf is secure before
placing items on shelf.
>> Handle tempered glass shelves
carefully. Shelves may break
suddenly if nicked, scratched, or
exposed to sudden temperature
change.
SPILLPROOF SHELVES
Spillproof Shelves hold
simple spills for easier
cleaning.
> To remove shelves, lift
up and out.
> To install shelves, reverse above
procedure.
Spillproof Slide-out
Shelves
feature the
convenience of
easy cleaning
with a pullout
design to reach
items in the back. For ease of cleaning,
glass shelf may be removed by pulling
to full extension and lifting out of frame.
DOOR S!0RAG{
BEVERAGE
COMPARTMENT
(SOME MODELS)
The temperature-controlled beverage
compartment keeps beverages and
other items colder than the rest of the
fresh food section. Air inlet allows air
from the freezer section to pass to the
beverage compartment.
Controls
The control is located on the left wall of
the fresh food section. Control adjusts
amount of air circulating in the beverage
compartment. Turn control clockwise for
colder temperature.
To remove and install the beverage
compartment:
If located directly above the beverage
compartment, dairy center or door
bucket may need to be removed.
Refer to appropriate instructions and
remove item.
Slide the
beverage
compartment
assembly up
and pull
straight out.
>■ To install, align one of the cold air
intake holes (A) with one of the two
air inlets (B) in door liner. Push
assembly down onto door liner
retainer until it stops.
IMPORTANT: The beverage
compartment will not operate properly if
air intake holes are not aligned with air
inlet in door liner.
DAIRY CENTER
The Dairy Center provides convenient
storage for items such as butter, yogurt,
cheese, etc.
This compartment is an adjustable
feature located in the door. It can be
moved to several different locations to
accommodate storage needs.
To remove and install bin:
5^ To remove,
slide dairy
center up and
pull out.
5^ To install, slide
assembly in
above desired door liner retainer and
push down until it stops.
To remove and install dairy door:
To remove, press in sides of dairy
door and pull out.
>■ To install, slide sides of dairy door
inside dairy center until hinge points
snap into place.
TILT-OUT DOOR BUCKETS
(SOME MODELS)
The Tilt-Out Bucket assembly consists
of a bucket and frame, providing
adjustable, convenient storage for food
items in door. The bucket assembly tilts
forward for easy access of items, and
lifts out for ease in cleaning and
adjusting.
To remove and install bucket:
To remove
bucket, tip bucket
forward and pull
straight out to
remove.
>- To install bucket, slide bucket into
bucket frame and push bucket
upright.
To adjust bucket frame:
> Remove bucket per
above instructions.
5^ Lift frame off door
support and place in
desired door location.
DOOR BUCKETS
Door Buckets adjust to meet individual
storage needs.
To remove, slide bucket
up and pull straight out.
To install,
reverse above
procedure.
O
CO
15