How to rtmovt odors from refrigerator, Fkergy saying ideas, How to remove and replace light bulbs – Kenmore 596.50002100 User Manual

Page 24: A warning, A caution, Upper fresh food, Section, Lower fresh food, Section b, Freezer section

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

HINTS ÂNDCÀRLcoKT.

HOW TO RTMOVT ODORS

FROM REFRIGERATOR

1. Remove all food.

2. Disconnect refrigerator.

3. Clean the following items-paying

special attention to crevices-using
the appropriate instructions in

How to

Clean Your Refrigerator:

• Walls, floor, and ceiling of cabinet

interior.

• Drawers, shelves, and gaskets.

4. Wash and dry all bottles, containers,

and jars. Discard spoiled or expired

items.

5. Wrap or store odor-causing foods in

tightly-sealed containers to prevent

reoccurring odors.

6. Connect power to refrigerator and

return food.

7. After 24 hours, check if odor has

been eliminated.

If odor is still present...

1. Remove drawers and place on top

shelf of refrigerator.

2. Pack refrigerator and freezer

sections-including doors-with
crumpled sheets of black and white

newspaper.

3. Place charcoal briquettes randomly

on crumpled newspaper in both
freezer and refrigerator
compartments.

4. Close doors and let stand 24-48 hours.

5. Repeat steps 5 through 7 above.

If odor was not eliminated, contact

Sears Service Center. Refer to back of

manual for phone number.

fKERGY SAYING IDEAS

Avoid overcrowding refrigerator
shelves. This reduces effectivity of air
circulation around food and causes

refrigerator to run longer.

> Avoid adding too much warm food to

refrigerator at one time. This
overloads compartments and slows

rate of cooling.

> DO NOT

use aluminum foil, wax paper,

or paper toweling as shelf liners. This
decreases air flow and causes
refrigerator to run less efficiently.

>■ A freezer that is % full runs most

efficiently.

3^ Locate refrigerator in coolest part of

room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If

this is not possible, isolate exterior by

using a section of cabinet or an
added layer of insulation.

Refer to section in Use and Care
Guide on temperature controls for
recommended control settings.

> Clean door gaskets every three

months according to use and care
guide instructions. This will assure
that door seals properly and
refrigerator runs efficiently.

3> Take time to organize items in

refrigerator to reduce time that door

is open.

> Be sure your doors are closing

securely by leveling refrigerator as
instructed in your use and care guide.

>■ Clean condenser coils off as

indicated in the Use and Care Guide
every 3 months. This will increase
energy efficiency and cooling
performance.

HOW TO REMOVE AND

REPLACE LIGHT BULBS

A WARNING

To avoid electrical shock which can

cause severe personal injury or death,

disconnect power to refrigerator

before replacing light bulb. After
replacing light bulb, connect power.

A CAUTION

To avoid personal injury or property
damage, observe the following:

>- Allow light bulb to cool.

>- Wear gloves when replacing light

bulb.

UPPER FRESH FOOD
SECTION

1. Locate finger

gaps on each
side of clear light

shield. Insert
fingers and press in on each side of
shield. Pull shield down and remove.

2. Remove light bulbs.

3. Replace with appliance bulbs no

greater than 40 watts.

4. Replace light bulb cover by inserting

front tabs of light shield into slots

directly in front of light assembly.

LOWER FRESH FOOD
SECTION

B

1. Pinch bottom tabs

(A) on light cover

and pull straight

out.

2. Remove light bulb.

3. Replace bulb with appliance bulb no

greater than 40 watts.

4. Insert top tabs (B) of light cover into

liner slots and snap bottom portion

over light assembly.

FREEZER SECTION

1. Remove ice bin by

A

lifting front of bin

and pulling out.

q

\\ ^

B

2. Remove light bulb

cover by pinching top tab

(A) and pulling cover out.

3. Remove light bulb. Replace with

appliance bulb no greater than 40 watts.

4. Insert bottom tab (B) of light cover

into liner slots and snap top portion

over light assembly.

5. Replace ice bin by sliding in until bin

locks into place.

ICE AND WATER
DISPENSER

1. Locate light bulb inside top edge of

dispenser frame. Unscrew to remove.

2. Replace light bulb with a

7-watt, 120 volt bulb.

Ik

3move.

i

Advertising
This manual is related to the following products: