Belt changing and agitator cleaning, To remove belt, To clean agitator – Kenmore 116.23812300 User Manual
Page 16: Vacuum use, Important, Disconnect cleaner from electrical outlet, Belt changing and agitator cleaning to remove belt
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
1. Turn Power
Mate® upside
down.
2. Unscrew the
two (2) Power
Mate® cover
screws.
3. Turn Power
Mate® right side
up. Press handle
release pedal and
lower the swivel.
Lift rear latches up.
4. To remove cover,
grasp the sides and
pull out.
5. Lift agitator
assembly out
and remove
worn belt.
6. Check and clean end cap areas. See
AGITATOR ASSEMBLY for picture of
complete agitator assembly.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu
um. the agitator must be cleaned every time
the belt is changed.
The agitator must also be cleaned accord
ing to the following schedule:
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
IMPORTANT
Clean Agitator
every week
every month
every 2 months
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build
up frequently in the Power-Mate® agitator
and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
16