To replace belt, Light bulb changing – Kenmore 116.23812300 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REPLACE BELT
1. Install new
belt over motor
drive, then
over brush
sprocket.
NOTE: See
PARTS AND
FEATURES
for belt num
ber.
2. Place agitator
assembly back
into Power-Mate®
4
. Rotate
cover back.
Press cover
firmly until side
and rear tabs
snap into
place. Turn
Power-Mate®
upside down
and replace
two (2) cover screws.
3. Line up
front of
cover and
base. Rest
cover on
front edge
of base as
shown.
LIGHT BULB CHANGING
1. Remove Power-Mate cover as shown in
BELT CHANGING AND AGITATOR CLEAN
ING section.
2, Push in and turn
bulb counterclock
wise, then pull out
to remove.
3. Push in and turn
bulb clockwise, to
replace. Bulb must
not be higher than
15 Watts(130 Volts).
4
. Reinstall Power-Mate cover as shown in
BELT CHANGING AND AGITATOR CLEAN
ING section.
NOTE: See PARTS AND FEATURES for
bulb number.
17