Kenmore ENVIROSENSE 85500 - Manual (Page 4)

Uaiitg tha Remote Control
Improper use:
• Any location where there is inverter
lighting equipment or electronic
spontaneous lighting equipment.
• When cleaning unit is located in direct
sunlight, as suntighi may Interfere with
the infrared sensor.
• In areas where fluorescent lighting is
flickering due to worn out bulbs­
Proper use:
• Operate with the remote control facing
the air cleaner.
• Operate vmthtn 23 feet of the air cleaner.
• Make sure there are no objects between
the remote centre! and the unit.
OPERATING THE REMOTE CONTROL
Use the POVtER button to turn the power
ofT and off. A short beep will sound when
you turn the unit on or off. Once the unit
is on, It will automatirailly switch into
Automatic operation. Turn the unit to
manual coniroi by pressing one of Ihe
FAN CONTROL buttons.
OFF TIMER
This button is used to set the timer.
Press the button repeatedly to set the
unit to run for 1, 4, or 8 hours or to
cancel. Each time you press the button,
it will advance to the next pre-set amount
of time. The indicator light on the unit
will show the remaining amount of time.
The unit will stop operating when the set
amount of time runs out.
FAN CONTROL
■ UP
Use this button to switch from
Automatic operation and increase the
fan speed level.
• DOWN
Use this button to decrease the fan
speed level.
TURBO
Use this button to switch from
Automatic operation and begin the
maximum amount of room cleaning
and air movement.
' AUTOiSLEEP
Use this button to switch between
Sleep, operation and Automatic
operation.
‘ PLASMA CONTROL
Use this button to turn the
Plasma Doctor on or off.
AIR CLEANER SET-UP
Note: Follow these instructions for best
results.
■ Place unit at least 7 feet from equipment
that emits electric waves such as
televisions or radios.
• Place unit at least 2 feet from the wall.
• Keep sensors away from drafty areas.
• Keep curtains away from sensors, as
they may interfere with air intake/oullet.
• Place unit on a stable surface with plenty
of air circulation.
1. Remove protective film from the control
panel.
2, Remove the front panel by pulling gently
on the silver labs
located on each side
of (he unit.
4. Remove the plastic wrap from the
filter cassette.
5, Place the filter cassette back mto m c
main unit.
6, Replace the front panel by hooking the
panel on the top pf the
unit. Swing panel in
by pushing gently on
the silver tabs located
on each side of the unit
and then lock it into
place.
7. Plug in the power cord to a wall outlet.
8- Press POWER button until a short “beep*
IS heard.
3.Pull out the filter cassette by grasping the
black tabs located
on each side.
For the first 4 minutes after the unit is
turned on, the unit will check the air
quality, and the dust and odor pollution
level indicators wilt flash.
T)
im