For your benefit, Benefit, For your – Kenmore 3950145 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
C. CONNECT DRAIN HOSE
for your
Benefit
Proper connection of the drain hose
wiil protect your floors from damage
due to water leakage.
STEP 1
. To prevent the drain hose from
coming off or leaking, it must be installed
per the following instructions:
iMPORTANT:
To ensure proper installa
tion, this procedure must be followed
exactly.
a. Wet the inside of the straight end of
the drain hose with tap water. DO
NOT USE ANY OTHER LUBRICANT.
b. Squeeze ears of silver, double-wire
clamp with pliers to open. Place clamp
over the straight end of the drain hose
V
4
inch from the end.
c. Open clamp. Twist hose back and
forth while pushing down onto drain
connector at the bottom of the washer.
Continue until hose contacts the
ribbed stop on the cabinet.
d. Place clamp over area marked
“CLAMP.” Release clamp.
If you have:
You will need to buy:
Drain hose that is too short
Drain hose, Part No. 388423 and
hose kit, Part No. 285442
Drain hose that is too long
Hose kit, Part No. 285442
A problem with lint clogging your drain
Drain protector, Part No. 367031
Parts listed are available from your local Sears store or Sears Service Center.
Call 1-800-366-PART (1-800-366-7278).
14