Caring for your washer, Cleantng your washer, Exterior – Kenmore 3950145 User Manual

Page 32: Interior, Water inlet hoses, Winter storage or moving care, To winterize washer, Non-use or vacation care

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CARING FOR YOUR WASHER

CLEANtNG YOUR WASHER

Proper care of your washer can extend

its life. This section explains how to care
for your washer properly and safely.

Exterior

Wipe up detergent, bleach, and other
spills with a soft, damp cloth or sponge
as they occur. Occasionally wipe the
outside of the washer to keep it looking
like new.

Do not put sharp or metal objects in your

washer. They can damage the finish.
Check all pockets for pins, clips, money,
bolts, nuts, etc. Do not lay these objects
on your washer after emptying pockets.

Interior
Clean interior with 1 cup of chlorine
bleach mixed with 2 cups of detergent.

Run washer through a complete cycle
using hot water. Repeat process if
necessary.

NOTE: Remove hard water deposits using
only cleaners labeled as washer safe.

WATER INLET HOSES

Replace inlet hoses after five years

of use to reduce the risk of hose

failure. Periodically inspect and

replace inlet hoses if bulges, kinks,

I cuts, wear, or leaks are found. When

replacing your inlet hoses, mark the
date of replacement on the label with
a permanent marker.

WINTER STORAGE OR

MOVING CARE

Install and store your washer where
it will not freeze. Because some water
may stay in the hoses, freezing can

damage your washer. If storing or

moving your washer during freezing

weather winterize it.

To winterize washer:

1. Shut off both water faucets.

2

. Disconnect and drain water inlet

hoses.

3. Put 1 quart of R.V.-type antifreeze

in the basket.

4. Run washer on a SPIN setting for

about 30 seconds to mix the anti­
freeze and water. Some of the mixture
will pump out while the washer spins.

5. Unplug the power supply cord.

To use washer again:

1. Flush water pipes and hoses.

2

. Reconnect water inlet hoses,

3. Turn on both water faucets.
4. Reconnect power supply cord.
5. Run the washer through a complete

cycle with 1 cup of detergent to clean
out antifreeze.

NON-USE OR VACATION CARE

Operate your washer only when you
are at home. If you will be on vacation or
not using your washer for an extended
period of time, you should;

• Unplug the power supply cord or turn

off electrical power to the washer.

• Turn off the water supply to the washer.

This helps avoid accidental flooding

(due to a water pressure surge) while

you are away.

32

Advertising
This manual is related to the following products: