Grill lighting instructions, Lighting instructions – Kenmore 141.168600 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

A

warning

A strong gas smell, or the hissing sound of

gas indcates a serious problem with your gas
grill or fie LP gas tank. Failure to immedi­
ately falow the steps listed below could result

in a fire or explosion that could cause seri­
ous boiHy injury, death, or property damage.

• Shut off gas supply to the gas grill.

• Turn the control knobs to OFF position.

• Put out any flame with a fire extinguisher.

• Open grill lid.
• Get away from the LP gas tank.
• Do not try to fix the problem yourself.
• If odor continues or you have a fire you

cannot extinguish, call your fire department.

Do not call near the LP gas tank

■ because your telephone is an electrical

device and could create a spark resulting

in fire and/or explosion.

Checking For LP Gas Leaks

Never test for leaks with a flame. Prior to first
use, at the beginning of each season, or every
time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:

1. Make a soap solution by mixing one part

liquid detergent and one part water.

2. Turn fte grill control knobs to the full OFF

position, then turn the gas ON at source.

3. ^ply fie soap solution to all gas connec­

tions. S bubbles appear in the soap solution
the connections are not properly sealed.
Check each fitting and tighten or repair as
necessary.

4. If ywi have a gas leak that you cannot

repair, turn off the gas at the source, discon­
nect hiel line from your grill and call

1-80(M-MY-HOME or your gas supplier for

repair assistance.

Grill Lighting Instructions

Basic Liglhting Procedures

1. , Famifarize yourself with the safety guidelines at

the front of this manual. Do not smoke white

lighting grill or checking gas supply connections.

2. Be

the LP gas tank is filled.

3. Checkthat the end of each burner tube is properly

located over each valve orifice.

4. Makesure all gas connections are securely

tightened.

5. Openfie Grill Lid or Side Burner Lid, depending

on theburner you are lighting.

A

warning

Failure to open Grill or Side Burner Lid
during the lighting procedures could
result in a fire or explosion that could
cause serious bodily injury, death, or
property damage.

6. Set control knobs to OFF and open the LP gas

tank valve slowly until 1/4 to 1/2 open.

7. For grill lighting push and turn the LEFT control

knob to HIGH. To light the Side Burner turn its

control knob to HIGH.

8. Immediately press the electric ignitor for 3-4

seconds to light the burner.

9. If the burner does not light, turn the control knob

to OFF, wait 5 minutes for gas to clear, then retry.

"10. Once the left grill burner is ignited, the adjacent

burner can be iit by simply turning its control knob

to HIGH,

11 Adjust control knobs to your desired cooking

temperature.

Lighting Your Grill by Match

To light your gas grill by match, follow steps 1 through
6 of the Basic Lighting Procedures. Then, insert a lit

nriatch through the lighting hole on either side of the

grill. See Fig, 16, Turn the nearest control knob to
the HIGH setting to release gas. The burner should

light immediately.

Figure 16

A

warning

Never lean over the grill cooking area while
lighting your gas grill. Keep your face and
body a safe distance (at least 18 inches)
from the lighting hole or burners, when
lighting your grill by match.

17

Advertising