Kenmore 790.9911. - Manual (Page 9)

Setting Surface Controls
FEATURE OVERVIEW
• Recommended Surface Cooking Settings / • Operating Single Surface Radiant Controls
Recommended Surface Cooking Settings
i Recommended settings for the Single, Bridge & Triple Surface Radiant Cooktop Elements
Setting
HIGH (8.0 - Hi)
MEDIUM HIGH (5.0 - 8.0)
MEDIUM (3.0 - 5.0)
MEDIUM LOW (2.0 - 4.0)
LOW/SIMMER (Lo - 2.0)
Type of Cooking
Start most foods, bring water to a boii or pan broiling
Continue a rapid boil, fry or deep fat fry
Maintain a slow boii, thicken sauces and gravies or steam vegetables
Keep foods cooking, poach or stew (2.8 or lower is a simmer setting).
Keep warm, meit or simmer (2.8 or lower is a simmer setting).
Fig.1
Note: The size and type of cookware used will influence the setting needed for the best cooking results. The simmer
settings are used to simmer and keep larger quantities of foods warm such as stews and soups. The lower simmer
settings are ideal for delicate foods and melting chocolate or butter.
Operating Single Radiant Surface Elements
The cooktop has 2 SINGLE radiant surface elements; the
RIGHT REAR position (Fig. 2) and the LEFT REAR ONLY
element position may be used as single or a Bridge element
(See Fig. 3). Refer to Fig. 1 for recommended surface
cooking settings.
To Operate the Single Radiant Surface Elements:
Fig. 2
Right Rear Eiement Left Rear Eiement
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the pad for the desired element position until a beep is heard. The
display will show " -- ".
NOTE: Each time a pad is touched a beep will sound. If no further pads are touched within ,,
10 seconds the request to power the eiement ON will clear.
3. Touch the element position's once to turn ON the power level HI or lo
pad once for Lo (See Fig. 4). The Hot Surface indicator light will turn ON when the Lo i v
element becomes hot. ' .....
4. Each touch of the lo or Hi pad will decrease or increase the power level by 1/2
from 9.0 through 3.0. Simmer power levels between 3.0 and 1.0 will decrease or increase
by .2 increments. Lo is the lowest power level available. Note: The power level may be
adjusted at any time while the element is ON.
5. When cooking has been completed touch the pad once to turn the element OFF.
Each surface element provides a constant amount of heat at each setting. A glowing red
surface heating area extending beyond the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
Fig. 4
Note: The Hot Surface indicator light will remain ON if the cooktop is still hot and will
remain ON until the heating surface area has cooled sufficiently.
Radiant surface elements may appear to have cooled after they have been turned off. The glass
surface may still be hot and burns may occur if the glass surface Is touched before It has cooled sufficiently.
Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or
plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or
wooden spoons could catch fire if placed too close to the surface elements.
9
R ight
R ear
H ot S urface