Before you cali, Occurrence possible cause/solution – Kenmore 790.4139 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before You Cali
Solutions to Com m on
Problems
Before you call for service,
review this list. It may save you time and expense. The list includes common occurrences
that are not the result of defective workmanship or materials in this appliance.
OCCURRENCE
POSSIBLE CAUSE/SOLUTION
Oven
Control
Beeps and Displays
any F code
error
(example F11).
Electronic control has detected a fault condition. Press
STOP/CLEAR
to clear
the display and stop beeping. Reprogram the oven. If a fault reoccurs, record
the fault number. Press
STOP/CLEAR
and call Sears or another qualified
servicer.
d-0 is displayed.
The door was left open and controls set for self-cleaning cycle. Close the door.
Range
not
level.
Poor baking results.
Place oven rack in center of oven. Place a level on the oven rack. Contact
installing agent if rack and cabinet cutout flooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
Entire oven does not operate.
When the oven is first plugged in, or when the power supply to the oven has
been interrupted, the display will flash. The oven cannot be programmed until
the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven.
Contact Sears or another qualified servicer.
Service wiring not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under
Setting
Oven
Controls
to set the controls.
House fuse has blown or circuit breaker has tripped immediately following
installation. House fuse may not be fully engaged. Check fuse and screw or
engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating. Call Sears or another qualified servicer.
Oven light does not work.
Burned-out or loose bulb. Follow the instructions under
Changing Oven Light
to replace or tighten the bulb.
Fan noise during cooking
operation.
A cooling fan may automatically turn on and off to cool internal parts. This is
normal, and the fan may continue to run even after oven is turned off.
22