Kenmore 790.4139 - Manual (Page 9)

Setting the Clock
Note: The time of day must first be set in order to operate the oven.
To Set the Clock
When the range is first plugged in, or when the power supply to the appliance has been interrupted, the display will show
" 12 : 00 " and flash PF (power failure).
1 . Press once (do not hold pad down).
2. Within 5 seconds, press and hold the yv or -v until the correct time of day appears in the display.
3. To reject the change, press
0
.
If the pad is not touched the change will be accepted after 5 seconds.
Note: The clock cannot be changed during any bake or seif-clean cycle.
Changing Between 12 or 24 HourTime of Day Display:
1 . Press and hold (0) for? seconds. After? seconds, "12h" or "24h" will appear in the display and the control will beep
once.
2 . Press either yv or to switch between the 12 and 24 hour time of day display.
3. Wait 5 seconds to accept the changes or press (^p) to cancel and return to the time of day display.
4. Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was
chosen, the clock will riow display time from 0:00 tfirough 23:59 hours.
To Set the Minute Timer
1 . Press
2 . Press the yv to increase the time in 1 minute increments. Press and hold y^ pad to increase the time faster. The
timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
3. The display shows the timer countdown in seconds when you set the minute timer for less than 59 minutes. When
the minute timer is set for more than 1 hour the display shows the timer countdown in minutes.
4. When the set time has run out, the timer will beep until is pressed.
Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the
set time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute
timer is in use with any other function, the function countdown will be shown in the display.
To Cancel the Minute Timer before the set time has run out: Press UI.E
To Set Add 1 Minute Feature
When the pad is pressed, 1 minute is added to the Minute Timer feature if it is already active. If the Minute Timer
feature is not active and the pad is pressed, the Minute Timer feature will become active and will begin counting
down from 1 minute.