Kenmore 790. 4789 - Manual (Page 10)

The TIMER and FLEX CLEAN pads control the Continuous Bake or 12 Hour Energy Saving features. The oven
control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is left on for
more than 11 hours and 59 minutes. The oven can be programmed to override this feature for Continuous Baking.
To set the co nt ro I 91* nupuf Bake or 12 Hour Energy Savin ^features
Setting the Clock
Setting Continuous Bake or 12 Hour Energy Saving
INSTRUCTIONS
1. Press and hold for 7 seconds (Figurel). After 7 seconds T2h" or
-h" will appear in the display and the control will beep once.
2. Press to switch between the 12 Hour Energy Saving and
continuous bake features. Note: "12h" (Figure 2) in the display indicates
the control is set for the 12 Hour Energy Saving mode and -h" indicates
the control is set for the Continuous Bake feature (Figure 3).
3. Press CSTART) to accept the change (Figure 4; display will return to time
DISPLAY
START
of day) or press (^) to reject the change. or [STOP
Setting Kitchen Timer
--------Figure 4
The TIMER niifjfff) pad controls the Kitchen Timer feature. The Kitchen Timer serves as an extra timer in the kitchen that will
beep when the set time has run out. It does not start or stop cooking. The Kitchen Timer feature can be used during any of
the other oven control functions. Refer to “Minimum and Maximum Control Pad Settings” for time amount settings.
PRESS INSTRUCTIONS
To set the Kitchen Timer (example for 5 minutes)
1. Press will appear and "TIMER" will flash in the display
(Figure 5).
2. Press the number pads to set the desired time in the display (example
CD)
Press START . The time will begin to count down with "5:00"
DISPLAY
Figure 5
START
and "TIMER" will stay in the display (Figure 6). Note: If is not
pressed the timer will return to the time of day after 25 seconds.
3. When the set time has run out, "End" and "TIMER" will show in the
display (Figure 7). The clock will sound with 3 beeps every 5 seconds
b u y
Figure 6
until is pressed.
To cancel the Kitchen Timer before the set time has run out
■in
Figure 7
Press The display will return to the time of day.
To Set Add 1 Minute Feature
The ADD 1 MINUTE pad is used to set the Add 1 Minute feature. When the pad is pressed, 1 minute is
added to the Minute Timer feature if this feature is already active. If the Minute Timer feature is not active and the (f^ ^
pad is pressed, the Minute Timer feature will become active and will begin counting down from 1 minute. For further
information on how to set the Minute Timer feature see To Set the Minute Timer instructions above.
10