To set the clock (example below for 1:30), Instructions, Press – Kenmore 790. 4789 User Manual
Page 9: Changing between 12 or 24 hour time of day display, Display, U llu, Setting the clock
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1).
When PF appears in the display, press PF will disappear.
To set the clock (example below for 1:30)
INSTRUCTIONS
Setting the Clock
Setting the Clock
PRESS
1. Press (^)- "CLO" will appear in the display (Figure 2).
2. Press
® CD®
pads to set the time of day to 1:30
(Figure 3). "CLO" will stay in the display. Press
"CLO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold for? seconds. AfterTseconds, "12h" (Figure
5) or "24h" (Figure 6) will appear in the display and the control will
beep once.
2
.
Press
to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3.
Press . START, to accept the change or press to reject the
change.
4.
Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
®®®
START ,
for 7 seconds
START / or
(
stop
laiOG FF
Figure 1
DISPLAY
Figure 2
B
n r I h
U L L U
Figure 3
Figure 6