Cleaning the burner assembly, Food safety, How to tell if meat is grilled thoroughly – Kenmore 415.165059 User Manual

Page 10: Cleaning, Burner assembly, Turn gas off at control knobs and lp cylinder, Clean, Separate, Cook, Chill

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Cleaning

the

Burner Assembly

Follow these instructions to clean and/or replace parts of burner

assembly or if you have trouble igniting grill.

1. Turn gas off at control knobs and LP cylinder.

2.

Remove cooking grate and heat tent.

3.

Under grill remove grease cup, disconnect ignitor wire from

burner.

4.

Inside grill remove burner assembly (A), clean ceramic

portion of electrode with rubbing alcohol and a swab.

5.

Clean outside of burner with soap and water. Lay burner

upside down on flat surface, insert garden hose to force

water through tubes. Make sure water comes out of all

burner holes. Open clogged holes with a thin wire. Shake

out excess water and examine holes. Due to normal wear

and corrosion some holes may become enlarged. If any

large cracks or holes are found replace burner.

6.

If grill is to be stored, coat burner lightly with cooking oil.

Wrap in protective cover to keep insects out.

7.

If not storing grill after cleaning, replace burner into grill

bottom.

VERY IMPORTANT: Burner tubes must re-engage valve

openings. See illustration (A).

8.

Reattach ignitor wire to electrode.

9.

Reposition heat tent and cooking grate. Reattach clean

grease cup to grease clip.

10. Before cooking again on grill, perform a “Leak Test”and

“Burner Flame Check”.

Correct

burner-to-valve engagement

:

A

Burner Tube--------- -

...

Valve

B

Food Safety

Food safety is a very important part of enjoying the outdoor

cooking experience. To keep food safe from harmful bacteria,

follow these four basic steps:

Clean:

Wash hands, utensils, and surfaces with hot soapy water

before and after handling raw meat and poultry.

Separate:

Separate raw meats and poultry from ready-to-eat

foods to avoid cross contamination. Use a clean platter and

utensils when removing cooked foods.

Cook:

Cook meat and poultry thoroughly to kill bacteria. Use a

thermometer to ensure proper internal food temperatures.

Chill:

Refrigerate prepared foods and leftovers promptly.

For more information call: USDA Meat and Poultry Hotline at
1-800-535-4555 (In Washington, DC (202) 720-3333,10:00 am-

4:00 pm EST).

How To Tell If Meat Is Grilled Thoroughly

• Meat and poultry cooked on a grill often browns very fast on the

outside. Use a meat thermometer to be sure food has reached

a safe internal temperature, and cut into food to check for

visual signs of doneness.

• Whole poultry should reach 165° F. Juices should run clear and

flesh should not be pink.

• Hamburgers made of any ground meat or poultry should reach

160° F, and be brown in the middle with no pink juices. Beef,

veal and lamb steaks, roasts and chops can be cooked to 145°

F. All cuts of pork should reach 160° F.

• NEVER partially grill meat or poultry and finish cooking later.

Cook food completely to destroy harmful bacteria.

• When reheating takeout foods or fully cooked meats like hot

dogs, grill to 165° F, or until steaming hot.

WARNING:

To ensure that it is safe to eat, food must be cooked

to the minimum internal temperatures listed in the table below.

USDA* Safe Minimum Internal Temperatures

Fish

145°F

Pork

160°F

Egg Dishes

160°F

Steaks and Roasts of Beef,

Veal or Lamb

145°F

Ground Beef, Veal or Lamb

160°F

Whole Poultry (Turkey,

Chicken, Duck, etc.)

165°F

Ground or Pieces Poultry

(Chicken Breast, etc.)

165°F

‘United States Department of Agriculture

10

-464722309

-464722509

Advertising