Kenmore 415.165059 - Manual (Page 18)

Burner and Firebox and Control Knobs
Place burner assembly into firebox. Fasten the burner assembly to the firebox using 5x15 fiber washers and #10-24x1/2”
machine screws (A).
Inside firebox, insert heat diffuser supports with 5x15 fiber washers to firebox through sides of firebox, then secure with
#10-24 flange nuts on outside of firebox (A).
Place firebox on cart. Make sure burner tubes are correctly engaged with valves. If burner is not level from left to right,
adjust the two screws attaching valve to control panel. Attach ignitor wire to ignitor ( B ).
Attach firebox with #10-24x2” machine screws, 5x15 fiber washers and #10-24 flange nuts ( C ).
Push control knobs onto valve stems ( C ).
^ Burner assembly
rebox
4...
\ Heat diffuser
k support
Control Knob
Heat shield
for Tank
Valve ■
o
#10-24
Flange Nut
Qty.8
5x15
Fiber Washer
Qty.10
%
#10-24X1/2”
Machine Screw
Qty.6
Heat diffuser Support
Qty.4
c
Make sure the burner tubes are located
underneath Heat Shield
18 -464722309 -464722509