Turbozonetm wash area, Fold-down tines, Knife holder – Kenmore 665.1629 User Manual

Page 11: To remove the knife holder

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TURBOZONETM wash area

The

TURBOZONE™

wash

area

is

located

at

the

back

of

the

lower

dishrack.

TURBOZONE™ wash area

Load pots, pans, casserole dishes, etc. in the back of the
lower dishrack with the soiled surfaces facing the

TURBOZONE™ jets.

Tip items toward the rear of the unit between the back two

rows of tines to maximize coverage.

TURBOZONE™ wash area side view

IMPORTANT:

Only one row of items may face the

TURBOZONE™ jets. Stacking, overlapping, or nesting items
will prevent the TURBOZONE™ jets from reaching all of the
surfaces.

NOTE:

You

must

select

the

TURBOZONE™

wash

option

to

utilize

this

wash

feature.

Do

not

face

items

toward

the

rear

of

the

unit

if

you are not using this wash option.

Fold-down tines

You can fold down one row of tines at the back of the bottom

rack.

1.

Grasp the tip of the tine that is in the tine holder.

2.

Gently pull the tine out of the tine holder.

3.

Lay the row of tines down in the rack to make room for larger

dishes, bowls, pots, pans or roasters.

Knife holder

Use the knife holder on the left side of the bottom rack to hold
knives that are too large for the silverware basket. Place knives in

the holder as shown.

To remove the knife holder

1.

Slide up to release the hooks over the rack wire.

2.

Lift knife holder out of rack.

To install the knife holder

1.

Align the knife holder with the bottom rack as shown in the

illustration below.

2.

Place the bottom slotted guide over the vertical wire in the

side of the rack.

3.

Place the hooks, located on the back of the knife hoider, over

the center rack wire and gently push down to lock Into place.

A

A. Top alignment
B. Bottom slotted guide

C. Knife holder hooks

Load

the

silverware

basket

while

it

is

in

the

bottom

rack

or

take

the basket out for loading on a counter or table.

NOTE:

Unload

or

remove

the

basket

before

unloading

the

racks

to avoid spilling water droplets on the silverware.

■ Place sm all items such as baby bottle caps, jar lids, corncob

holders, etc., in a covered section. Close the cover to hold
small items in place.

1 1

Advertising
This manual is related to the following products: