Pioneer MJ-D508 - Manual (Page 34)

Copying Track Tracks
If you need to name several tracks with similar names—several parts of one suite, for example—^you can name the first one using
the procedure detailed above, then simply copy that name to the other tracks and edit them as required. This can save you a lot of
time over naming each track individually. The recorder stores the last three names you've copied using the name clip function in
its memory (up to 40 characters each). W hen you copy another track name, the oldest one is deleted from memory.
7
Go to the track with the name you want to copy.
❖ Use one of the usual methods—track skip, direct selection, etc.
^__
J
2,6
4
5
Press NAME CLIP to copy the currently displayed
name into memory.
The display should confirm that the track name has been copied.
❖ You cannot copy the track names of playback-only discs.
Go to the track that you want to copy the
name to.
❖ Use one of the usual methods—track skip, direct selection, etc.
Press NAME to start editing the current track name.
Move the cursor to the position you want to insert
the copied name.
Use the ◄◄ and ►► buttons to move the cursor around the character
display.
Press NAME CLIP again.
The display flashes Name Insert briefly and the most recently clipped
name appears.
Use the jog dial to select one of the previous three
names stored, then press the jog dial (ENTER).
On the remote, use the and buttons to select a name, then
press ENTER.
The selected name is inserted at the point you chose.
C tss 3 ......................
❖ Edit the name further if necessary.
8
Press NAME to leave the track name mode.
:PRB1285>