Kenmore 580.76100 - Manual (Page 10)

OPERATION
FEATURES
3 2 714
0 6 11 1210 13 16
FÏG. 2S4
1. Cabinet
2. Vertical Air
Directiofs Lowers
3. Horizofitei Air
Direction Louvers
4. Wet Griie
5. Air Filter
5. Front Gfiite
7, Ciontrot Panel
8. Power Cord
9. Evaporator Coit
10. Condenser
11. Compressor
12. Base jjan
13. Brace
14. Upper Guide
15. Curtain
16. Remote Control
USING THE AIR CONDITIONER
To reduce the risk of fire, sleclrtc
shock, or injury to persons, read the important
SAFETY instajctions secflon before operating this
appliance
To h^in operatlns the air condliloner after
tnstaUatlon, foflow Btase steps:
1. Plug in the air ooncfitioner. (To preverst elecfrical
hamrds-, do not use an extension cord or an
adapter plug.)
2. Set the exhaust vent to tti® CLOSE position.
3. Settle TEMP Control to the coolest setting.
4. Set the MODE control at the highest COOL isvsl.
6. Adjust ihs louvers for comfortaWe air tow.
6. Once the room has ooolad, adjust the TEMP and
Mode Control to the setting you find most
comfortable.
MOTE: If the air conditiotier is turned off, wait 3
minutes hetore restarSng. This allows pressure
inside the compressor to eguaBze. Failure to wait 3
minutes before restarting may cause inefficient
operatton.
If you move the TEMP Control to a warmer, then
Immediately bmvk to a cooler setting, the urrit will
shut off. WaB 3 minutes before restarting,
VINT CONTROL
The Vent Control allows the air OMiiftioner to
either rsclrcalste inside air (CLOSE) or exhaust
air to the outside (OPEN). (FIG. 25)
• The CLOSE position is used when maximum
cooRng m desired. It may also be used for air
Mcircuiatlon without cooling when toe air
conditioner is sat in the FAN position.
• Irte OPEN position removes state air from the
room and exhausts it to toe outeide. Fresh air is
drawn into the rootn through your home's
normal air passages.
• The OPEN or CLOSE position can be used wHh
any mode selecbon.