Pioneer PD-207 - Manual (Page 10)

CONVENIENT OPERATION FOR RECORDING
2 Designate the length of tape to be used.
When the digit buttons are used (PD-207 only):
Press the digit buttons to set the length (time) of the tape.
Press the 10's digit button and 1's digit button sequentially.
(To enter 9 minutes or less, press M and then the corresponding
digit button.)
When the track search buttons are used:
Press ◄◄ (or !◄◄) or ►► (or ►►!) to set the length
(time) of the tape.
• Each time the buttons are pressed, the time setting will
change in the following order:
46 ^ 54 60 ^ 74 90
I______________ ________________ I Unit: Minutes
• The displayed time is memorized and the player starts
calculating when COMPU/AUTO EDIT is pressed or if no
other time setting is selected within 3 seconds.
Example: The tape playing time of 46 minutes is selected.
COMPU PROGRAM EDIT
Side A
1 1 г П 1 1 Ш CD m ш
L I 0 I I L L •_'/ / CD ID
[¥-'
СЖЗ
Side в
*
n Г 1 .1 1 ■ 1 1
LI LI 0 L L J L ca ra
I pGH 1 СП EU [Л]
СП
AUTO PROGRAM EDIT
Side A
I l г
L l и
СГ"
l-l г
1 1 - П 1 Ш [D Ш Ш Ш
■ L -LI L CD
4
Side В
I l г 1 J l-ur.
LI LI о L 1 ' 1 LI CD CD CD oa
[7”
To confirm the programmed results:
After completion of programming, press COMPU/AUTO EDIT; each
time the button is pressed, the program results will be alternately
displayed for tape sides A and B.
NOTES:
• Up to 24 steps can be progrannnned.
• With discs containing 24 tracks or more, programming may not
be correctly performed.
• If the selected time is too short for any track to be programmed,
programming cannot be performed.
• If you wish to enter the time with the digit buttons after the
time is already entered with ◄◄ (or ым) or ►► (or
►Hj in step 2, press
I
>10\. The digit buttons can now be
operated.
• If the disc is in the player, the contents of the Сотри program
edit are not cleared even when the power is turned off.
However, if the power is turned off with an audio timer or by
unplugging the power cord, the program contents will be erased.
TIMER PLAYBACK
By using a commercially available audio timer, it is possible to
initiate playback at any time automatically.
1. Turn on the power to the player, load a disc into the disc tray
and close the disc tray with OPEN/CLOSE.
2. Set the time at which you wish playback to begin. The timer
will supply power to both the amplifier and the player at the
preset time, turning all the components on and initiating the
playback mode. Playback starts from the first track.
NOTES:
• If no disc has been loaded in the player, the player will enter the
standby mode when the audio timer turns the player's power
on.
• Pressing any function buttons before commencement of timer
start cancels the timer start function.
10
<XRB1002>