Pioneer PD-207 - Manual (Page 3)

ABOUT THESE OPERATING INSTRUCTIONS............................... 3
CAUTIONS REGARDING HANDLING............................................. 3
CONNECTIONS ............................................................................... 4
CONFIRM SUPPLIED ACCESSORIES........................................... 5
PUT BATTERIES INTO THE REMOTE
CONTROL UNIT............................................................................... 5
NAMES AND FUNCTIONS OF PARTS........................................... 5
BASIC OPERATION....................................................................... 6
VARIOUS OPERATIONS............................................................... 7
TO PLAY ONLY DESIRED TRACKS............................................... 8
CONVENIENT OPERATION FOR RECORDING............................. 9
TIMER PLAYBACK.......................................................................... 10
TROUBLESHOOTING.................................................................... 11
SPECIFICATIONS.... ........................................................ Back cover
The contents found in these Operating Instructions are based on
the PD-207 model, but they are also applicable to the PD-107
model.
Cleaning the player
To clean the PLAYER, wipe with a soft, dry cloth. For stubborn dirt,
wet a soft cloth with a mild detergent solution made by diluting one
part detergent to 5 or 6 parts water, wring well, then wipe off the
dirt. Use a dry cloth to wipe the surface dry. Do not use volatile
liquids such as benzene and thinner which are harmful to the unit.
Storing discs
Be careful not to allow discs to warp; always store discs in their
cases vertically, avoiding locations with high heat or humidity, or
extremely low temperatures.
CD lens cleaner
The player's pickup lens should not become dirty in normal use, but
if for some reason it should malfunction due to soiling, consult your
nearest PIONEER authorized service center. Lens cleaners for CD
players are commercially available, but special care should be
exercised in their use since some may cause damage to the lens.
AC power cord connection and functions
Some functions cannot be carried out depending on the connection
of the AC power cord.
Function
Timer playback
Program memory
Output level memory
When the AC power
cord is connected to
the unswitched outlet
of an amplifier or wall
outlet.
No
Yes
Yes
When the AC power
cord is connected to
the switched outlet
of an amplifier or
audio timer.
Yes
No
No
Location
Install the player in a well-ventilated location where it will not
be exposed to high temperatures or humidity.
Do not install the player in a location which is exposed to direct
rays of the sun, or near stoves or radiators. Excessive heat can
adversely affect the cabinet and internal components. Also,
installation of the player in a damp or dusty environment may result
in a malfunction or accident.
Precautions regarding installation
Avoid placing the player on heat-generating sources such as
amplifiers.
Install this compact disc player as far as possible from tuners
and TV sets. Noise may be particularly noticeable when an
indoor antenna is used. In such a case, make use of an outdoor
antenna, or turn off power to the compact disc player.
Please place this unit on a level surface.
Condensation
When this unit is brought into a v^/arm room from previously cold
surroundings or when the room temperature rises sharply,
condensation may form inside, and the unit may not be able to
attain its full performance. In cases like this, allow the unit to stand
for about an hour or raise the room temperature gradually.
Cleaning and handling compact discs
Always keep your discs clean by wiping them gently with a soft
cloth from the inner edge toward the outer periphery.
If a disc becomes very dirty, dip a soft cloth in water, and after
wringing it out well, wipe the dirt away gently, and then remove
any water drops with another soft, dry cloth.
Do not use record cleaning sprays or anti-static agents on discs.
Also, never clean discs with benzene, thinner, or other volatile
solvents, since damage to the disc surface may result.
With this player, use discs which display the mark shown below.
(Optical audio digital discs.)
When holding discs, do not touch their signal surfaces (the side
reflecting a "rainbow" pattern, opposite the label side). Hold by
the edges, or by one edge and the center hole.
Do not affix gummed labels or tape to the label surfaces. Also,
do not scratch or damage the label.
Discs rotate at high speed inside the player. Do not use damaged
(cracked or warped) discs.
DIGITAL AUDIO
NOTES:
• When setting an 8 cnn CD single, do not use the 8 cm CD single
adaptor.
• Never attempt to load both 8 cm and 12 cm discs together,
since disc damage or other malfunctions may result. Always
load only one disc at a time.
3
<XRB1002>