Brother CM-2000 - Manual (Page 27)

Setting Up Your Typewriter
Afterthe paper has been inserted, press[RETURN]to move the carrier to the left margin
position. When you are in normal typing mode, you will be prompted to do this.
PRESS RTN-
S’^U Yr'L MUL'-L,
Notes!
The distance the paper is fed in will determine the position of the first typing line in
relation to the top edge of the paper (the top margin). You can adjust this using the
START SET function, as described later. The factory setting of the top margin is one
inch.
If the paper is crooked or not properly aligned after automatic insertion, it may be
adjusted manually. First turn the platen or use [INDEX] to feed more paper through,
then pull the paper release leverfoiw/ard. This will liftthe paper bail and release the paper
so that it may be moved manually. Align the paper until it is straight, then return the
paper release lever to its back position and turn the platen knob or use [INDEX] and
[R INDEX] to return the paper to the position where you wish to begin typing. For
finer adjustment, use these keys with the [CODE] key held down.
Manual Paper Adjustment
If the paper is crooked or not properly aligned after automatic insertion, it may be adjusted
manually. First pull the paper bail lever forward to raise the paper bail
and avoid it catching
on the paper. Turn the platen knob or use [INDEX] to feed more paper through, then
pull the paper release lever forward. This will liftthe paper bail and release the paper so that
it may be moved manually. Align the paper until It is straight, then return the paper release
lever to its back position and turn the platen knob or use [INDEX] and [R INDEX] to
return the paper to the position where you wish to begin typing. For finer adjustment, use
these keys with the [CODE] key held down.