Kenmore 1232 - Manual (Page 30)

lii
ZIPPER APPLICATIOW
SETTINGS
Stretch Stitch Control,
Stitch Width Control .....
Stitch Length Control.....
Zipper Foot
.Horizontal
0
12
REGULAR ZIPPER
Pin or baste zipper to fabric and place
the work in position under the presser
foot. Loosen the zipper foot adjusting
screw to set the foot on the left side of
the needle, and sew the left side zipper
as shown. (Fig, 1i To sew the right'
side zipper, loosen the screw and bring
the foot to the right side of the needle.
INVISIBLE ZIPPER
Adjust the foot so the needle is sewing
through
the center hole of the foot
and one groove of the foot is riding on
the teeth of the zipper, See Fig, 2. Fol­
low the zipper manufacturer's instruc­
tions.
After zipper has been inserted, finish
sewing seam by shifting foot to side
position sewing through side notch,
CORDING
Foot can also be used to make cording
for slipcovers etc. Cover a cord with a
strip of bias fabric and sew as shown in
Fig. 3.
NOTE:
Use "Low Bar Sewing Machine ZIP­
PER FOOT" (6757) for "invisible
zipper" and "cording", which will be
obtained at any stores of Sears Roe­
buck and Co,, and Simpsons-Sears
Limited