Pioneer CD-625 - Manual (Page 7)

Precautions Specifications
To assure proper operation of the unit, keep the vehicle interior
temperature within a normal range using the vehicle's air
conditioner of heater.
Keep the sound level low enough to let you hear the outside of
your car.
Enough care must be taken against battery overdischarge causd
by long operation of the set at a high sound level when the
engine is not running or is idling.
When replacing fuses, be sure to use only fuses of the rating
prescribed on the fuse holder.
In case of trouble
When the unit does not operate properly, contact your dealer
or the nearest authorized PIONEER Service Station.
Power source.............................DC 14.4 V (10.8 — 15.6 V allowable)
Grounding system............................................................ Negative type
Dimensions..............................................120(W) x 25(H) x 150(D) mm
Weight...........................................................................................0.6 kg
Gain......................................................................................................... 0 dB
Sub-woofer level control............................................-15 dB — -h15 dB
Frequency response......................................... 10 — 30,000 Hz (±1 dB)
Distortion........................................................... 0.05% (1 kHz, 500 mV)
Signal-to-noise ratio.........................................101 dB (lEC-A network)
Crossover frequency......................................................50 Hz — 200 Hz
Crossover slope
Low-Pass filter.............................................................. -12 dB/octave
High-Pass filter.............................................................-12 dB/octave
Phase switch..................................................................................0/180°
Nominal input level..................................................................... 500 mV
Max. input level..................................................................................2 V
Input impedance...................................................................................10 kil
Output impedance..................................................................................1 ki2
Max. output level............................................... ............................... 2 V
Note:
Specifications and the design are subject to possible modification
without notice due to improvements.
Precautions Specifications
To assure proper operation of the unit, keep the vehicle interior
temperature within a normal range using the vehicle's air
conditioner of heater.
Keep the sound level low enough to let you hear the outside of
your car.
Enough care must be taken against battery overdischarge causd
by long operation of the set at a high sound level when the
engine is not running or is idling.
When replacing fuses, be sure to use only fuses of the rating
prescribed on the fuse holder.
In case of trouble
When the unit does not operate properly, contact your dealer
or the nearest authorized PIONEER Service Station.
Power source.............................DC 14.4 V (10.8 — 15.6 V allowable)
Grounding system............................................................ Negative type
Dimensions..............................................120(W) x 25(H) x 150(D) mm
Weight...........................................................................................0.6 kg
Gain......................................................................................................... 0 dB
Sub-woofer level control............................................-15 dB — -h15 dB
Frequency response......................................... 10 — 30,000 Hz (±1 dB)
Distortion........................................................... 0.05% (1 kHz, 500 mV)
Signal-to-noise ratio.........................................101 dB (lEC-A network)
Crossover frequency......................................................50 Hz — 200 Hz
Crossover slope
Low-Pass filter.............................................................. -12 dB/octave
High-Pass filter.............................................................-12 dB/octave
Phase switch..................................................................................0/180°
Nominal input level..................................................................... 500 mV
Max. input level..................................................................................2 V
Input impedance...................................................................................10 kil
Output impedance..................................................................................1 ki2
Max. output level............................................... ............................... 2 V
Note:
Specifications and the design are subject to possible modification
without notice due to improvements.