Pioneer CT-W603RS - Manual (Page 18)

TAPE COPYING (from DECK I to DECK II)
• The tape copying function permits you to copy the contents of
a tape from DECK I to DECK II.
• The SYNCHRO COPY button is used to select either normal
speed copying, or high-speed copying (copying at twice the nor­
mal playback speed).
1. Load a tape for playback into DECK I and a tape for
recording into DECK II.
2. Set the REV MODE switch.
3. Set the tape transport direction.
• Tape copying is always performed in the direction indicated
by the tape transport indicator (►or -^). To change this direc­
tion, press the desired playback button (► or ◄), then im­
mediately press the stop ( ■ ) button.
4. Press the SYNCHRO COPY button to select either
NORMAL or HiGH speed.
NORMAL: Tape copying at normal speed allows listen
during playback (COPY indicator lights
steadily).
HIGH: Tape copying at twice the normal speed
(COPY indicator flashes). Playback will still
audible.
To stop copying
Press the stop ( ■ ) button of either deck. Both decks will stop.
NOTES:
• The tape in DECK // will be copied in the same type of the DOL­
BY NR switch as DECK I's tape, regardless of its own setting.
When listening to the copied tape, set the type of the DOLBY
NR switch on DECK /.
• If a nearby television set is on while high-speed copying is be­
ing performed, a high-pitched interference sound may be heard
on the tape. In this case, either use the normal speed copying
function, or turn off the television.
• During high-speed copying, none of the operation buttons will
function except for the stop iU ) button.
• During normal speed copying, the recording mute ( QI and
pause IH) buttons of deck H also function.
• Tape copying is cancelled when either of the two tapes reaches
the end. Therefore, it is advisable to use tapes of the same
length.
• The sound quality of the copied tape will be somewhat less than
the original. Therefore when making more than one copy, al­
ways record from the original tape (do not make a copy of a
copy).
• The recording level adjustment is not necessary during tape
copying.
18
<RRB1143>
En