Code selection after mode download, 1 tv1, 2 tv2 – Kenwood RC-R0905 User Manual
Page 15: 3 cable, Press a numeric key
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RC-R0905 [Ert]
Hold your remote to the speaker portion of
your telephone.
15
For each setup code the operator can supply a setup code numpen
Should you ever need to change your tnput configuration, this number
can be used. Please record tor your future reference. If for some reason
this information is lost, see -ChecKing a setup code" m the "Setup code
correlation" section for further into-'mation.
Code selection after mode download
step 5 above, the remote control automatically enters a special set*up mode which works
.After successful completion of the downloa
as described below.
Select the component for which you want
to register the information downloaded
above.
Press the VIDEO, AUDIO, or TV
key repeatedly to select the de
sired component.
AUDIO
O
2
O
VIDEO
key
AUDIO
key
TV
key
1
TV1
2 TV2
3 CABLE
Example 1 : To register a code at the component connected to the
VIDEO 1 lacks, select "VIDEO 1 (VCR)".
r* 1 VIDEOI(VCRI)
1 CD (CD)
2 V1DE02 (VCR 2)
2 TAPE1/MD
3 VIDEOS (LD)
(TAPE)
_ 4 V1DE04 (DVD)
_ 3 PHONO
Perform each of the following steps within
5 seconds.
Press a numeric key.
Press the 1 key to output the POWER code of the first component on
your list in step □ of the previous page. Continue to push buttons 2
Through 9 (and 0) until the component you want to register turns on.
■Though the FutureSet memory in your remote control is quite large,
only 10 setup POWER codes can be put on the 10 keypad at any one
time. If you require a larger download, the standard setup procedure
can be used. See "Registering setup codes for other components", your
customer service representative can supply you with the downloaded
setup code numbers.
Repeat steps 1 and 2 to register all of the
downloaded information.
Hold down the ENT key until the backlight
flashes twice.
ROOM В
0
■The setup code for the last POWER code to be sent in step B is
automatically registered at the location selected in step □.
■ At this time, the remote exits the special set-up mode and returns to
Its
normal operation mode.