Remote control system infrared, Specifications – Kenwood RC-R0905 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
if)-';-' Syn^itom;;
■ • m£i\
The backlight flashes five times during nor
mal operation.
• The batteries are nearing exhaustion.
• Replace with new batteries to preserve the
currently registered setup information.
Certain
inputs
cannot
be
selected
using
the remote control.
• No preset codes registered at for the respec
tive inputis'l.
• Register a preset code or Non-IR code at the
respective input(s).
Remote control operation is not possible.
• The remote control is set to a different opera
tion mode.
• Press VIDEO, AUDIO, or TV to select the
approriate operation mode.
• Batteries are exhausted.
• Replace with new batteries. If the backup is
exhasted before you can replace the batter
ies, redo the setup procedure.
• The remote control unit is too far away from
the mam system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
* Operate the remote control unit within the
controllable range.
• The audio cords and system control cords are
not connected properly
• Connect properly.
• No software is loaded in the source compo
nent
• Place software m the source component you
want to play.
• An attempt is nnade to play a tape which is
being recorded in the cassette deck.
• Wait until recording has completed.
• The remote control has not been set to the
operation mode for the component you wish
to control.
• Press the VIDEO, AUDIO, or TV key to activate
the operation mode tor the component you
want to control before operation.
• The rem.ote control is m the Room B (A)
operation mode.
• Change the operation mode. - JT,
•
The
nmcroprocessor
of
the
remote
control
malfunctions
• Reset the microprocessor. —
23
Do ocv 056 contact cleaning age-’'- tiecaose mev couic cause a malfunction. Be specifically careful against using contact cleaning agents
cc''i:am''g o: . since tney "^lav an’ ■■'o tne plascc c:-"'ponents
Specifications
Remote control system................................................ Infrared
Transmitter power supply.............................................. 6 V DC
Dimensions.............................................. W : 62 mm (2-7/16")
....................................................... H : 227 mm (8-15/16")
........................................................... D : 37 mm (1-7/16")
Weight (Excluding batteries).............................. 170 g (0.4 lb)
^cD’■.^uGD tQ. O'.vs a policy of co’'t '' .n-.c'- aovancer”e''*s m aevelopnnent. For this reason specifications may be changed without notice.