In case of difficulty – Kenwood DVR-6100 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
In case of difficulty
DVR-605/DVR-6100/DVR-6I00K (ENI
What seems to be a malfunction is not always so. Before calling for service, check the following table according to the symptom
of your trouble.
Operation to reset
The microcomputer may fall into malfunction (impossibility
to operate, erroneous display, etc.) when the power cord is
unplugged while power is ON or due to an external factor. In
this case, execute the following procedure to reset the
microcomputer and return it to normal condition.
Set the POWER switch to ON (set to Standby
mode). Then press the key, i<4 key and STOP
key in this order.
•
Please
note
that
resetting
the
microcomputer
clears
the
contents
stored
in
and
returns
and
to
condition
when
it
left
the factory.
Receiver, speakers
Symptom
Cause
Remedy
Sound is not produced.
•
The speaker conis are disconnected.
•
The
MUTE
switch of remote control unit is
switched ON
•
The headphone plug is inserted into the
jack
•
Connect properly referring to "Systemcon-
nection",
•
Switch
MUTE OFF.
•
Unplug the headphone plug
Sound is not produced from the left
or right speakers.
•
The speaker cords are disconnected.
•
Connect properly referring to “System con
nection".
Radio stations cannot be received.
•
The antennas have not been connected.
•
A proper broadcasting band has not been
selected
•
The frequency of the station to be received
IS
not tuned.
•
Connect antennas.
—Q£l
•
Select a band.
—
CA]
•
Tune to the frequency of the desired sta-
tion.
-OS
Noise interferes.
•
Car ignition noise.
•
influence of an electric appliance
•
A TV set is installed near the system
•
Install the outdoor antenna in an apart posi
tion from the road.
—Qd
•
Switch the suspected electric appliance
OFF.
•
Install the TV or the system at an increased
distance between them.
A station has been preset but it can
not be received by pressing the
P.CALL key.
•
The frequency of the preset station is not
tunable
•
The preset memory has been cleared be
cause the power cord has been unplugged
for a long period
•
Preset stations with tunable frequencies.
•
Preset stations again.
—Q2
The STANDBY indicator flashes red
rapidly.
•
The temperature protection inside the unit
has operated because of an excessive
volume
•
Leave the unit with the powe off for about
15 minutes, and then turn the power on. If
this does not help, contact your dealer for
service.
No sound from the surround speakers
•
The Listen mode is STEREO.
•
Select Surround with the
Listen mode
key.
—[JJ]