Delay, Priority, Weather – Uniden UBC 175xL User Manual
Page 11: Delay priority
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DELAY
Your scanner can be programmed to pause for about three seconds after a
transmission ends on any selected channel. This is useful when both sides
of a conversation are transmitted on the same frequency.
To program Delay on a selected channel:
PRESS:
PRESS:
MANUAL I step to that channel.
DELAY
]
Display: DELAY The delay message will be displayed
To remove Delay:
PRESS;
^DELAlJ The message will disappear.
PRIORITY
It is often desirable to be alerted to a transmission occurring on a channel other
than that to which you are listening. The priority feature samples any frequen
cy which has been entered into channel 1, every 3 seconds.
If a signal is detected on the priority frequency, (channel 1) when sampled,
the receiver will remain tuned in to it until the transmission ceases, at which
time the scanner will revert to the last mode of operation.
To activate the priority function:
PRESS:
The priority message will be displayed.
To remove priority:
PRESS:
PRI 1 again and the priority message will disappear.
WEATHER
Searches all seven NOAA weather frequencies until locking on the one active
ly broadcasting in your area.
To search for local weather:
PRESS:
PRESS:
MANUAL
WX
I
Display will indicate the weather frequency
being received.
11