Uniden UBC 175xL - Manual (Page 9)

Example: To search between 152.150 МНг and 155.575 MHz on channel 2:
PRESS И MANUAL ]
Display: jP X X X . X X X
PRESS; Q Q Q Q Q Q L I i ^
Display: ^ ? S /50
decimal will enter automatically.)
PRESS: Q Q Q Q Q Q Q L ™
Display; ¿> ? S 5 , 5 7 5
PRESS: SRCH
NOTE: X denotes the digits of the previously programmed frequency.
When an active frequency is found, the SEARCH stops and the frequency is
displayed.
During your search, record (on paper) the frequency numbers you wish to re­
tain as you identify them. Later you can program these individual frequencies
into memory channels or press and the frequency displayed wilt im­
mediately be programmed into the indicated channel. Search is not affected
and may be continued.
To remain on a frequency after the signal goes off the air:
PRESS: ^HOL d J Y ou may now press HOLD ^ to step higher in
frequency which will sometimes produce clearer reception. You
may also press LIMIT to step lower in frequency again,
to improve reception or just to select a new frequency. If
[I]
is pressed, the frequency in the display will be
entered into the memory channel being displayed.
To resume searching within the same limits:
PRESS: SRCH
To remove search:
PRESS: MANUAL or SCAN , search will turn off.