Crestron electronic ST-PC - Manual (Page 14)

Dual AC Power Control Module Crestron ST-PC
Configuration Manager is where programmers “build” a Crestron control system by
selecting hardware from the Device Library. In Configuration manager, drag the
PRO2 from the Control Systems folder of the Device Library and drop it in the upper
pane of the System Views. The PRO2 with its associated communication ports is
displayed in the System Views upper pane.
PRO2 System Views
The System Views lower pane displays the PRO2 system tree (refer to the following
graphic). This tree can be expanded to display and configure the communication
ports.
Expanded PRO2 System Tree
C2Net-Device Slot in Configuration Manager
To incorporate an ST-PC into the system, drag the ST-PC from the Cresnet Control
Modules | Cresnet Power Control Modules folder of the Device Library and drop it
in System Views. The PRO2 system tree displays the ST-PC in Slot 9, with a default
Net ID of 2C as shown in the following illustration.
NOTE: The first ST-PC in a system is preset with a Net ID of 2C when its symbol is
dragged into the upper pane of System Views. Additional ST-PC units are assigned
different Net ID numbers as they are added.
10 • Dual AC Power Control Module: ST-PC Operations Guide – DOC. 5708A