Crestron electronic ST-PC - Manual (Page 19)

Crestron ST-PC Dual AC Power Control Module
NOTE: The parameters shown in the illustration above are the port settings for a 2-
Series control system. Consult the Operations Guide for the control system being
used for the exact parameter selection.
4. To verify communication, select Diagnostics | Establish Communications
(Find Rack). This should display a window that gives the COM port and
baud rate. If communications cannot be established, refer to the
“Troubleshooting Communications” section in the respective Operations
Guide for the control system.
Uploading a SIMPL Windows Program
A control system source file has
the extension .smw. A compiled
SIMPL Windows file has the
extension .spz for a 2-Series
control system, .bin for CNX
generation, and .csz for CNX
generation with SIMPL+. The SIMPL Windows file can be uploaded to the control system using SIMPL
Windows or via the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the “Open” window, navigate to the SIMPL
Window file (.smw), and click Open.
3. Select Project | Transfer Program.
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that begins on
page 13 has been performed.
2. As shown after this step, select File Transfer | Send Program
(Alternatively, press Alt+P) from the Viewport menu.
File transfer | Send Program Command
3. The “Send Program” window appears as shown after this step. Click
Browse, locate the completed file (.spz for PRO2) and click Open. This
displays the program’s header information and enables one or both of the
What to Send check boxes. If the program does not contain any SIMPL+
modules, only the SIMPL Program check box is enabled. If it does contain
SIMPL+ modules, then the SIMPL+ Program(s) check box will also be
enabled. Select one or both check boxes and then click Send Program to
begin the transfer.
NOTE: Refer to the respective Operations Guide for control system details about the
other fields in the “Send Program” window.
Operations Guide – DOC. 5708A Dual AC Power Control Module: ST-PC • 15