Kenwood DM-VH7 - Manual (Page 6)

Installation Installatinn
The front feet attached at the factory can be replaced with the provided replacement feet.
When you want to stack the RD-VH7 (optional) above this unit, installed this unit horizontally by using
the provided horizontal installation spacer.
Check the following accessories
Replacement front feet............................................. 2
Spacer for horizontal installation........................... 1
Allen wrench.............................................................. 1
Remove the MD and unplug the power cord be­
fore proceeding to the following operation.
Only the front feet can be replaced.
When attaching replacement front feet, use only
the screws which have been used with the re­
moved feet. (Using other screws may result in a
fire or malfunction.)
If this unit is fell down by mistake after installation
and if an MD is left inside the unit, the MD may be
damaged.
Changing the installation method
Horizontal, stacked installation (When stacking the optional RD-VH7 above the unit)
Use the provided spacer for horizontal installation.
O Attach the spacer by inserting its claws into the
spacer mount holes on the rear of the this unit.
IlMOTEiWhen inserting the claws, align them
with the holes by tilting the spacer slightly
(about 20 degrees) as shown in the illus­
tration.
©Arrange the cords by winding them around
the spacer.
The audio cords and system control cord can be
accommodated Into the trench on the spacer by
winding them as shown in the illustration.
©Stack the RD-VH7 by aligning its feet with the
foot support cavities on the spacer.
Vertical installation
Change the left front foot location as described below.
O Using the Allen wrench, remove the 2 screws
from the front foot located on the left when
the unit is seen from the front.
StepO
Front feet removed in step O
©Align the removed front foot with the
threaded holes on the rear part of the right
side panel, and attach the front foot using the
screws removed in step Q.
Step ©
How to replace the front feet
The factory-attached front feet can be exchanged with the provided replacement front feet.
O Using the Allen wrench, remove the 4 screws
from each front foot.
©Attach the provided replacement front feet.
Attach using two of the 4 screws removed in
step O.
gggP'l
I
\/
Threaded holes
II
s
J/
LCD contrast adjustment (Main unit only)
The contrast of the LCD display can be switched as desired.
O Press the mode key.
© Press the or key to select "CONTRAST SET?", then press the enter key.
©Adjust the contrast by pressing the l-^-^ or key, then press the enter key.
• Press and hold the mode key for more than 2 seconds to reset the contrast to the Initial value.
Adjusting the display orientation (Main unit only)
With the initial setting, the display window of this unit switches the display orientation by automatically
(AUTO) detecting the vertical or horizontal installation. However, it is also possible to switch the
orientation manually (MANUAL) as desired.
Manual switching procedure
O Press the mode key.
View of the unit © Press the or key to select "WINDOW SET?", then press the enter key.
when it is placed © Press the l-^-< or key to select "MANUAL", then press the enter key.
vemcany
O Press the l-<-< or key to select the desired orientation, then press the enter key.