Toshiba IK-WB15A - Manual (Page 13)

0°o
Connecting the Camera and Personal Computer by Network
IP Address
To connect to the network, the administrator needs to set the IP address
of the network camera.
There are two options to set the IP address.
■ Obtaining an IP address automatically from the DHCP server
■ Entering an IP address manually
Obtaining an IP address automatically from the DHCP server
Your camera is set to get data automatically from the DHCP server
(DHCP ON/OFF is set to ON in "Network-Basic Settings") by default. If
your network is using a DHCP server, you do not need to change the IP
address of the camera.
• Entering the IP address manually.
• Manually enter the IP address when the DHCP server is not used or
when the DHCP server is not utilized even when connected.
• The IP address of the network camera is sometimes updated or
changed from time to time when the DHCP server is used. For this
reason, the network camera sometimes cannot be connected due to
an IP address change. (if the network camera is accessed using the
previously set IP address.)
To enable accessing the network camera in this case, a fixed IP ad­
dress needs to be set to the network camera. (Set an IP address
through manual input) Please also read the instruction manauls for
the network system equipment(router,hub and modem) carefully.
• When entering the IP address manually, set DHCP ON/OFF to OFF in
"Network-Basic Settings" on page 84 in User's Manual in CD-ROM
and enter the IP address, subnet mask, default gateway, primary DNS
and secondary DNS.
03