Toshiba IK-WB15A - Manual (Page 14)

0°o
Connecting the Camera and Personal Computer by Networtr (Cont.)
Connection Configuration
Two configurations are available for connecting a network cameras.
■ Crossover connection
■ Connection via a hub, switch, or router
•Using a crossover cable to establish a connection (example)
•Establishing a connection via a hub (example)
LAN cable (straight through) and Hub is not provided with the product.
^NOTE
You do not need to assign an IP address to a hub.
The IP address of your camera after purchasing from the store is automatically
set to 192.168.0.30 in case DHCp is not used. Set the IP address of your
personal computer in the same subnet. (The network segment must be the
same segment when directly connecting using a cross cable or connecting
through the hub)
When connecting more than one camera, connect each camera using IP
Address 192.168.0.30 and change the IP addresses of the second and
subsequent cameras to other IP addresses, such as 192.168.0.31.
You can also use the LAN port of your broadband router.
However, when using the broadband router, if the DHCP server function is
set to "ON", turn on the power after connecting the camera with the router.
The camera gets the IP address from the router's DHCP server and it may
not be 192.168.0.30.
For more information, read your user's guide for broadband router.
It is also recommended to set the computer's IP address from the router's
DHCP server.
For more information, read your computer's user's guide.