Toshiba IK-WB15A - Manual (Page 15)

Connecting Camera and Personal Computer
1 Connect LAN cable and turn the power on.
2
If you are using a hub, connect the LAN cable (straight cable) from
the camera to the hub. Power-up the camera.
If you are connecting the camera to a personal computer, with the
computer turned on connect the LAN cable (cross cable) from the
camera to the personal computer. Power-up the camera.
If using PoE connect the LAN cable (straight cable) from the
camera to the PoE hub. A PoE power supply is required.
Set the IP address of the personal computer.
• This step is used only if the camera is connected to the personal
computer. The IP address of the computer must be set up to
communicate with the camera. The camera is set to 192.168.0.30
so select an address that is close to the camera. An example would
be 192.168.0.25. The subnet mask number must be 255.255.255.0
.Please refer to the personal computers manual for the procedure.
• Set the IP address to 192.168.0.50 (and subnet mask to
255.255.255.0) as an example.
• For details on the procedure, refer to the user's guide of the personal computer.
3
Test the camera connection using ping.
• To locate the command prompt select start, select programs,
select accessories, start a command prompt. Type "ping
192.168.0.30" and press "Enter" key.
• If the "Reply from..." message appears, the connection is correctly established.
4
Search the camera by "Camera Finder" and view a
camera image.
1. Start "Camera Finder" and click the "Search" button.
■ Confirm that the camera name "nwcam15" is displayed in the camera list.
2. Click "nwcam15", to select.
■ Check that the camera name, IP address and HTTP port number
are displayed in the "Network Camera Log-in" field in the bottom.
3. Click the "Administrator" button or the "User" button.
■ When you click the "Administrator" button, a screen for inputting
the user name and password will appear. Enter the administrator
log-in ID and password.
■ Administrator login ID at the time of the purchase is set as "root",
and its password is set as "ikwb".
■ User login ID at the time of the purchase is set as "guest", and
its password is set as "guest".
4. A camera image screen of the network camera will appear.
^NOTE
To view images without using "Camera Finder," launch the Internet browser,
enter URL http://192.168.0.30/ in the address box and press "ENTER."
It takes about 30 seconds to activate the camera.
If a port number other than "80" is set, designate the port number by suffixing
it after ":" as in http://192.168.0.30:NN/,, where NN is the new port number.
A5