Optional саг cord adapter – RCA CC643 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Optional Саг Cord Adapter
The optional DCC08 car cord shown on
page 66 allows you to power your
camcorder from the cigarette lighter
socket of a car, truck, or RV. It converts
12-volts to a 6-volt output.
Note:
Consult the installation and operating
instructions enclosed with the DCC08 for
complete operating instructions.
Cautions: The.DGCOS is sdesÍ
5
ned.to^rf i
be used only with yehiclesAaving nl
a
i
»
negative ground jeleotrical isystents-.i; w c -
Use only car cord adapter DCC08 with
this camcorder. Use of any other cár
cord adapSéiay damage the Í
camcorder and void your warranty..
Using the DCC08 Car Cord Adapter
1. Place the POWER switch in OFF to
turn off the camcorder. Power
indicator on the camcorder turns off.
2. If the battery or DC cable is attached
to the camcorder, remove it.
3. Hold the top of the power connector
flush against the camcorder, and press
the bottom of the power connector
down until it locks into place.
4. Take the vehicle’s cigarette lighter out
of the socket.
5.
6.
Insert the car cord’s cigarette lighter
plug into the vehicle’s cigarette lighter
socket. The power indicator on the
car cord adapter will light.
Place the POWER switch in CAMERA
to turn on the camcorder. The power
indicator on the camcorder lights.
Caution:
sure the camcorder’s
power is turned off before rethoving
the car cord’s plug from the cigarette
lighter socket.
16