Playback on a tv without audioa^ideo inputs, Installation – RCA CC643 User Manual
Page 63
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Playback on a TV Without AudioA^ideo Inputs
To connect your camcorder to a TV without audio/video inputs, you will need an
optional 1CVA147C RF output adapter and an optional coaxial RF cable, such as VH82
or VH90
shown on page 68.
If your TV has
AUDIO
and
VIDEO
/V jacks (or is
connected to a VCR),
refer to pages 62-63.
Installation
1. Disconnect the VHF antenna from
your TV Connect the antenna to the
IN
FROM
ANT connector
on the RF
output adapter if you are going to
leave the adapter connected to the TV.
Note:
If your VHF antenna is the flat
twin-lead type attached by two screws,
you will also need an optional 300/75
ohm transformer.
2. Attach one end of the optional coaxial
RF cable to the
OUT TO TV
connector on the adapter, and attach
the other end to the VHF input on
your TV as shown.
Note:
If your TV has 300 ohm screw
terminals, you will need a 75/300 ohm
transformer, such as VH54, shown on
page 68.
3.
Attach the RF output adapter’s plug to
the
AUDIO, RF DC OUT,
and
VIDEO
jacks located under the small cover on
the side of the camcorder.
64