Cannondale SCALPEL 100 - Manual (Page 10)

10
SI BB30 Crankset Compatability
the BB shell is compatable with the BB30 standard. see http://www.bb30standard.com/ For
information see SI Cranksets Owner’s Manual Supplement. see http://www.cannondale.com/
tech/.
Bearing Maintenance
shell bearings (KB6180/) are sealed cartridge type and do not require lubrication. inspect
bearing condition annually (at a minimum) and anytime the crankset assembly is disassembled
or serviced. the bearings are a press fit within the shell. old bearings should not be reinstalled
if removed. replace both bearings at the same time.
replacements circlips (QC616/) are available if the circlips become damaged. the circlips can be
lifted from the BB groove (inset) by lifting the hooked end with a thin blade screwdriver.
CAUTION
DO NOT FACE, MILL OR MACHINE THE BOTTOM BRACKET SHELL FOR ANY REASON.
Doing so can result in serious damage and possibly a ruined bike frame.
Cannondale SI BB30 Tools
Kt011/ is a bearing removal tool. Kt010/ is a set of bearing installation tools to be used with
a standard headset press. Kt013/ a two piece tool set required for removing si Hollowgram
alloy cranksets. For information see SI Cranksets Owner’s Manual Supplement. see http://www.
cannondale.com/tech/.
SI BB30-to-68mm Standard Adapter
the adapter (Cannondale kit KF365/) converts the BB30 bottom bracket cranksets for use with
68mm bottom brackets.
the adapter is not a repair part and will only work in undamaged frames in good condition.
improper installation or removal can result in damage and void applicable frame warranty.