Subwoofer, Balancing your speakers, A sample set up for surround sound enjoyment – RCA RV-9978 User Manual

Page 6: First things first

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

FIRST THINGS FIRST

2, Aim the speakers directly at the two main

speakers, matching height to height. If the room is
sparsely decorated, it may be necessary to slightly
tilt the speakers down to increase sound
quality. If the room is densely decorated, it may be

necessary to face the speakers toward the rear

wall or at the ceiling.

3. Mount the speakers up on the ceiling. Set them a

few feet wide of the listeners and make sure they
are facing one another, not the floor.

Obviously there are many more possible positions, so it
may be necessary to simply experiment to find the
right balance for your situation.

SUBWOOFER

Before you begin, make sure that the subwoofer is

turned off and unplugged.

Connect your AA/ receiver to the subwoofer as shown.

NOTE: A receiver with a single output should be

connected to the input labeled LOW-LEVEL INPUT,

BALANCING YOUR SPEAKERS

Your system is equipped with

which

enables you to reproduce sound effects as they were

intended. But to do so, the speakers must be correctly

balanced.

To balance the speakers using the Test Tone, all
speakers must be connected to your receiver. Your
receiver must be in the Dolby Pro Logic Surround

Mode.

1. Press the TEST TONE button on the receiver front

panel. The receiver generates a "pink noise" and
applies it automatically at two-second intervals to
the left main channel, center channel, right main
channel and left and right rear channels

(simultaneously), in that order.

2. As the pink noise is generated, go to the spot in

the room where you are most likely to be when

listening to your system. The rear surround and

center speakers should be adjusted to equal the

level of output from the left and right main

speakers.

3. Make adjustments by pressing the REAR*CTR

button, and then the +/- button on your remote

control. The output from the selected speaker(s) is

adjusted accordingly.

SUBWOOFER

A SAMPLE SET UP FOR SURROUND
SOUND ENJOYMENT

Main

g|ffl|Center^|||

Main

Left

Right

6

Rear

Rear

Left

Right

L O G I C Manufactured under license from Dolby Laboratories Licensing Corporation. Dolby, the double-D symbol (□□) and

“ Pro Logic" are trademarks of Dolby Laboratories Licensing Corporation.

Advertising
This manual is related to the following products: