Chrysler 2009 Sebring Sedan - Owner Manual - Manual (Page 364)

6. If the vehicle is equipped with Sentry Key
௡ Immobi-
lizer, turn the ignition switch to the ON position for three
seconds before moving the ignition switch to the START
position.
7. Start the engine in the vehicle that has the booster
battery, let the engine idle a few minutes, and then start
the engine in the vehicle with the discharged battery.
8. When removing the jumper cables, reverse the se-
quence exactly. Be careful of the moving belts and fan.
9. Reinstall the protective cover over the remote jump-
start positive battery post.
WARNING!
During cold weather when temperatures are below
freezing point, electrolyte in a discharged battery
may freeze. Do not attempt jump-starting because
the battery could rupture or explode. The battery
temperature must be brought up above the freezing
point before attempting a jump-start.
NOTE: Refer to “Maintenance Procedures” in Section 7
of this manual for information on accessing the battery
for service or replacement.
362 WHAT TO DO IN EMERGENCIES