Chamberlain WD962KEV - Manual (Page 38)

37
Operation
Motion Detecting Control Panel (continued)
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls
while still allowing activation from the door control and keyless entry. This feature is useful for added
peace of mind when the home is empty (i.e. vacation).
l Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as
long as the lock feature is activated and your handheld remote control will not operate your
door at this time.
l Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will
stop flashing and normal operation will resume.
TIMER-TO-CLOSE
DO NOT enable TTC if operating a one-piece door. The TTC can be turned on or off and the time
interval can be adjusted to 1, 5, and 10 minute intervals. Once the TTC has been set and the door is
open, the selected close interval will blink and begin to count down to close the door.
l Activate: Press and hold the ON button until one of the TTC LEDs light up. Then press the ON
button again to cycle through the time interval options (the corresponding TTC LED will light
for each time interval). The garage door opener light bulbs will blink as confirmation.
l Deactivate: Press and hold the OFF button until all TTC LEDs turn off and a beep is heard
from the motor unit.
l Temporarily hold door open (suspend TTC): Press and release the HOLD OPEN button.
Press the HOLD OPEN button again to resume normal TTC operation.
PROGRAM
Any compatible remote controls, wireless keyless entry, or MyQ™ accessories can be programmed to the
garage door opener by pressing the Learn button.
ON (TTC)
OFF (TTC)
Command LED
Motion Sensor
Switch
LIGHT Button
HOLD OPEN
Button(TTC)
Motion Sensor
Push Bar
1, 5, and
10 Minute
TTC LED LEARN Button
LOCK Button
Using the Smart Control Panel
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until the garage door
opener activates (it may take up to 3 presses). Test the door control by pressing the push bar, each press
of the push bar will activate the garage door opener.
Push Bar
LIGHT Button
Motion Sensor
Navigation Buttons
Screen
SMART CONTROL PANEL FEATURES
PUSH BAR
Press the push bar to open or close the door.
LIGHTS
Light Button
Press the LIGHT button to turn the garage door opener lights on or off. When the lights are turned on
they will stay on until the LIGHT button is pressed again, or until the garage door opener is activated.
Once the garage door opener is activated the lights will turn off after the specified period of time (the
factory setting is 4-1/2 minutes). The LIGHT button will not control the lights when the door is in motion.
The duration of the light timing can be adjusted by accessing the menu using the navigation buttons.
Motion Sensor
The motion sensor will automatically turn on the garage door opener lights when motion is detected. The
lights will come on for the set period of time, then shut off. The factory setting is on and set at 4-1/2
minutes.