Clippasafe 122 Pressure Fit Gate - Manual (Page 4)

3
4
5
Place the gate in the desired opening and push the latch downwards gently.
The screw adjusters will
extend and the latch
should ‘click’ into place
indicating that the gate
is secure. If you feel a lot
of resistance STOP and
screw the screw adjusters
further into the frame.
Check the pressure
indicators on the top and
bottom corners of the frame. When the gate is under no pressure, the red
plastic indicator should be completely visible. When the gate is closed and
under pressure the wide part of the red plastic indicator, should be
completely invisible indicating that the gate is under enough pressure.
If the wide part of the red indicator is still visible the screw adjusters need to
be adjusted. Open the
latch and using the
spanner ‘E’ loosen the
nuts ‘B’ and adjust each
of the screw adjusters so
they extend further from
the frame. This will
increase the pressure.
Continue to adjust the screw adjusters until the wide part of the red
indicator disappears when the gate is securely closed. Make sure that
the distance between the wall
and the gate is no less than
22mm and no more than
55mm on the handle side.
Make sure that the distance
between the other side of the
gate and the wall is no less
than 18mm and no more than
63mm. Tighten the nuts ‘B’
with the spanner ‘E’.
clac
max 55mm
min 22mm
max 63 mm
min 18 mm
!