Clippasafe 122 Pressure Fit Gate - Manual (Page 7)

Fitting a 7cm Extension
Remove the screw adjusters ‘A’, nuts ‘B’ and the casings ‘C’ from the hinge
side of the gate (1). Turn the screw adjuster casings ‘C’ upside down and
re-insert them into the frame (2). They should extend slightly from the
frame. Attach the extension ‘F’ onto the casings (3). Fasten the screw
adjusters ‘A’ and nuts ‘B’ into the extension ‘F’ (4).
G
Fitting a 14cm Extension H
Remove the screw adjusters ‘A’, nuts ‘B’ and the casings ‘C’ from the hinge
side of the gate (1). Place the long end of the extension ‘I’ directly into the
frame making sure that the notches are facing downwards (2). Attach the
extension ‘F’ to the short end of the extension ‘I’ (3). Fasten the screw
adjusters ‘A’ and nuts ‘B’ into the extension ‘F’ (4).
1
C
A B
C
A B
2 3
F
4
1
C
A B
C
A B
2
I
3
F
4
1
Fitting a 7cm & a 14cm Extension Together
Remove the screw adjusters ‘A’, nuts ‘B’ and the casings ‘C’ from the hinge
side of the gate (1). Insert the long end of the extension ‘I’ directly into the
frame making sure that the notches are facing downwards (2). Place the
tops ‘J’ onto both ends of the slat ‘K’ (3). Place this on the short end of
the extension ‘I’ (4).
Insert the small casings ‘H’ into the open ends of the tops ‘J’, making sure
that the top notch is facing downwards and the bottom notch is facing
upwards (5). Add the extension ‘F’ to the extruding end of
the casings ‘H’ (6). Fasten the screw adjusters ‘A’ and nuts ‘B’ into the
extension ‘F’ (7).
I
1
C
A B
C
A B
2
I
3
J
K
J
4