COMEUP Automotive Winch (Ver:00) - Manual (Page 13)

Winching Procedures
12
Preparation before Winching
1). Connect the remote control
Always disconnect the remote control when not in use.
Always have the remote control kept free from winch,
wire/synthetic rope and roller/hawse fairlead.
2
2). Disengage clutch function
Lift the clutch T-handle up and turn it at 90°
counter-clockwise rotation to the “Disengaged” position,
rope can now clutch off the drum.
3). Pull the wire/synthetic rope to the anchor point
Wear leather gloves when handling wire/synthetic rope.
Pull out enough rope to reach the anchor point. Be careful
to keep the rope under tension.
4). Engage clutch function
To engage, lift the clutch T-handle up and turn it at 90°
clockwise rotation to the “Engaged” position. Never engage
the clutch while the drum is rotating.
Winching Operation
1). Check the wire/synthetic rope
Before winching, make sure the rope is wound on the drum
evenly. If there is a mixed winding, it is essential to rewind
it evenly.
2). Lay a recovery damper over the rope near the hook
end.
If a wire/synthetic rope failure occurs, the damper can
prevent the rope from whipping.