COMEUP Automotive Winch (Ver:00) - Manual (Page 16)

Maintenance
15
Wire Rope Replacement
Do not wind out past the red paint section of the rope to secure the anchorage of the rope on the
drum.
1). Disengage the clutch T-handle.
2). Spool the entire rope, and then remove it from the drum.
3). Place the replacement rope through the roller fairlead opening, pass below the drum and insert
it into the hole on the drum core. Tighten the set-screw downwards to secure the wire rope.
4).A minimum of five (5) wraps of rope around the drum is necessary to support the rated load
Synthetic Rope Replacement
Do not wind out past the red paint section of the rope to secure the anchorage of the rope on the
drum.
1). Disengage the clutch T-handle, remove existing rope and replace hawse if necessary.
2). Remove the set-screw on the drum and spool out the rope from the drum.
3). Cut the lateral side of the end by 45° and apply 2-3 wraps of electrical tape to hold cut strands
in place
4). Thread rope through a hawse fairlead and under the drum, insert the rope through the hole on
the drum with 15 – 20 cm / 6” – 8”.
5). Place rope across the drum and tape the end down to hold it in place. Lightly tighten the
set-screw to squeeze the rope, do not over tighten.
6). A minimum of ten (10) wraps of rope around the drum is necessary to support the rated load
Tape
(Engage) (Disengage)