COMEUP ATV/UTV Winch (Ver:04) User Manual
Page 6
4
1. It is very important that the winch shall
be mounted on a flat hard surface in
order to make sure the motor, drum and
gearbox housing are aligned correctly.
2. If a different mounting plate is used, the
thickness shall be at least 5 mm (3/16”).
If different hardware is used, it must be
SAE grade 8 minimum.
3. Four (4) included M8x 25L Grade 8.8
High Tensile Steel Bolts must be used
for securing the winch on the mounting
plate in order to sustain the loads imposed on the winch mounting.
4. Two (2) M8 x 20L Grade 8.8 High Tensile Steel Bolts (supplied) must be used for securing
the roller/hawse fairlead on the mounting plate.
Winch & Roller Fairlead/Hawse Fairlead Mounting
1. It disconnects your winch from the power source when the vehicle is not in use.
2. It should be mounted close to the battery and keep the location from all metal structures.
Contactor Mounting
A fully charged battery and good connections are essential for the proper operation of your winch.
The minimum requirement for battery is 500 cold cranking amp.
Battery Recommendations
(Cub 2s / 3s / 4s only)