COMEUP Chain Hoist (Ver:02) - Manual (Page 6)

I I . Handing Precautions
4
To prevent the risk of electric shock, the power plug must be plugged into a matching outlet and
grounded in good condition.
Never try to lift a load higher than the rated cap.
Never hitch a ride on the hook, sling or load being moving.
Chain hoist is not to be used for lifting or lowering people.
Don’t work, walk or stand under an operating chain hoist.
Always remain in control. Never neglect the chain hoist while actually hosting a load.
While working, never stand under a lifting load or within the conveying area.
Always look up when working around chain hoist, there is potential danger overhead.
Never gravitate a load free.
Be sure to lift a load vertically..
Prior to starting of use, carry out the daily checking without fail, and after confirming the safety
of function.
If having a counter rotation incurred, make sure to correct its rotation direction.
Prior to lift. Make sure to have a precise performance of brake. If any malfunction of brake happened,
stop the operation immediately.
When load suspended in air, it will not allow to be welding.
Load chain with any remarkable wears and elongations shall be removed or replaced immediately.
Stop the operation if there is any queer noise or vibration in the gear box to be happened.
Do not connect the load chain with the grounding of welding machine.
While welding, do not have any contact with the welding objects because of having spark.
Do not pull the switch.
Do not over the rated intermittent period.
Do not operate beyond the limits of the load chain travel
Be sure to fix a load chain in the center of load hook.
Be sure to stop operation immediately when the load chain becomes fully slackened.
Avoid catching the hook or lifting a load on a fixed obstruction.
Always leave the pendant switch positioned immediately after use.
Make sure that the load being lifting is well balanced and secured before starting.
Avoid water splashes on the pendant switch and electrical circuits.
Never wrap the load with the load chain.
A power cut-off switch located below the house lights red, please stop the hoisting immediately.
Please reset the switch by hand after reducing a load by manual
The hoist is equipped an up mechanical torque limit device, it activates when over-riding
operation found. It does not allow to activate for more than 6 seconds, otherwise it may damage
the hoist endurance.