Application socket configuration – Comtrol UP DeviceMaster Quick Start User Manual
Page 31
DeviceMaster UP EtherNet/IP Quick Start: 2000478 Rev. D
Application Socket Configuration - 31
Application Socket Configuration
Access the Application TCP Connection Configuration section corresponding to the desired serial or socket
port:
1.
Select Enable.
2.
If your Ethernet TCP/IP application
requires another device to connect to it,
configure the socket port on the
DeviceMaster UP to Connect mode:
a.
Make sure that the Listen option is
not selected.
b.
Set Connect To Mode to Connect-
Always.
c.
Set the Connect Port to the socket
port number of your Ethernet
application.
d.
Set the Connect IP Address to the IP address of your Ethernet application.
e.
Set Disconnect Mode to Never.
3.
If your Ethernet TCP/IP application is
configured to connect to another device,
configure the socket port on the
DeviceMaster UP to Listen mode:
a.
Select Listen.
b.
Use the default Listen Port on the
DeviceMaster UP of 8xxx or
designate your own.
c.
Set Connect To Mode to Never.
d.
Set Disconnect Mode to Never.
e.
Configure your Ethernet application to connect to the DeviceMaster UP at the DeviceMaster UP IP
address and Listen Port.
4.
If you do not know if your application will connect to another Ethernet device, but do know your
application’s socket port and IP address, you can do the following to enable both the Listen and Connect
modes:
a.
Select Listen.
b.
Use the default Listen Port on the DeviceMaster UP of 8xxx or designate your own.
c.
Set Connect To Mode to Connect-Always.
d.
Set the Connect Port to the socket port number of your Ethernet application.
e.
Set the Connect IP Address to the IP address of your Ethernet application.
f.
Set Disconnect Mode to Never.
g.
Optionally configure your Ethernet application to connect to the DeviceMaster UP at the
DeviceMaster UP IP address and Listen Port.